RAW WATER CIRCUIT (open circuit)
Number of cylinders 10
Raw water pump: Inlet pressure, min. L bar -0.4
Raw water pump: Inlet pressure , max. L bar +0.5
Pressure loss in off-engine raw water system, max. L bar 1.2
LUBE OIL SYSTEM
Number of cylinders 10
Lube-oil operating temperature before engine, from R °C 75
Lube-oil operating temperature before engine, to R °C 83
Lube oil operating pressure before engine, from R bar 8.0
Lube oil operating pressure before engine, to R bar 9.0
Lube oil operating pressure (low idle) (meas. point: before engine) R bar 2.5
FUEL SYSTEM
Number of cylinders 10
Fuel pressure at engine supply connection, min. (when engine is starting) L bar -0.3
Fuel pressure at engine inlet connection, min. (when engine is running) L bar -0.3
Fuel pressure at engine inlet connection, max. (when engine is starting) L bar +0.25
Fuel supply flow, max. R Liter/min 5.9
GENERAL OPERATING DATA
Number of cylinders 10
Firing speed, from R rpm 100
Firing speed, to R rpm 120
STARTER (electric)
Number of cylinders 10
Starter rated voltage (standard design) R V= 24
INCLINATIONS, STANDARD OIL SYSTEM (Reference: waterline)
Number of cylinders 10
Longitudinal inclination, continuous max., driving end down (Option: max.
operating inclinations)
L Degrees
(°)
15
Longitudinal inclination, temporary max., driving end down (Option: max.
operating inclinations)
L Degrees
(°)
20
Longitudinal inclination, continuous max., driving end up (Option: max. op‐
erating inclinations)
L Degrees
(°)
5
Longitudinal inclination, temporary max., driving end up (Option: max. oper‐
ating inclinations)
L Degrees
(°)
10
Transverse inclination, continuous max. (Option: max. operating inclina‐
tions)
L Degrees
(°)
22.5
Transverse inclination, temporary max. (Option: max. operating inclinations) L Degrees
(°)
35
MS150062/01E 2012-01 | Technical Data | 35
TIM-ID: 0000010810 - 001
To Next Page