Need help?Do you have a question about the MTX RT501 and is the answer not in the manual?
Matches input sensitivity to source unit, operating range 100mV to 6V.
Selects active low pass (LPF), high pass (HPF), or turns crossover off (FULL).
Adjusts the high-pass crossover frequency from 40Hz to 400Hz.
Adjusts the low-pass crossover frequency from 40Hz to 400Hz.
Accepts source units with RCA or Line level outputs (min 100mV).
Used for daisy-chaining multiple amplifiers.
Indicates power status; blinks for short-circuit or thermal protection.
Connects to source units with speaker-level outputs.
Main power input, connect directly to the vehicle's positive battery terminal.
Turns the amplifier on/off via a 12V signal from the source unit.
Connects to the vehicle chassis for proper grounding.
Connect speakers here, ensuring correct polarity for sound quality.
Protect the amplifier; replace only with the same value fuse.
Connects the External Bass Control for on-demand bass adjustments.
To Next Page
General
