Warranty:
One Year – Frame and Drive All Models
One Year – Models 5000 and 4400 Power Heads
Three Year – Model 23, 25, 35 37 and 40 Power Heads
Five Year – Drive Casting All Models
Manufacturer’s Emissions Warranty Coverage:
If any emission related part on your engine is defective, the part will
be repaired or replaced by Briggs and Stratton or Mud Buddy.
Owner’s Warranty Responsibilities:
As the engine owner, you are responsible for the performance of the
required maintenance listed in your owner’ manual. MUD BUDDY LLC
recommends that you retain all your receipts covering maintenance
on your engine, but MUD BUDDY LLC cannot deny warranty solely for
the lack of receipts or for your failure to ensure the performance of
all scheduled maintenance.
As the engine owner, you should however be aware that MUD
BUDDY LLC may deny warranty coverage of your marine engine or
a part has failed due to abuse, neglect, improper maintenance or
unapproved modications.
You are responsible for presenting your engine to a MUD BUDDY
LLC Service Dealer as soon as a problem exists. The warranty repairs
should be completed in a reasonable amount of time. If you have any
questions regarding your warranty rights and responsibilities, you
should contact a MUD BUDDY LLC Service Representative at
1-801-352-8011.
Manufacturer Emissions Control Warranty Provisions
The following are specic provisions relative to your Emissions
Control Warranty Coverage. It is in addition to the manufacturer
engine warranty for non-regulated engines found in the Operator’s
Manual.
1. Warranted Emission Parts
Coverage under this warranty extends only to the parts listed below
(the emissions control systems parts) to the extent these parts were
present on the engine.
a. Fuel Metering System
- Cold start enrichment system (soft choke)
- Carburetor and internal parts
- Fuel pump
- Fuel line, fuel line ttings, clamps
b. Air induction system
- Intake manifold
- Purge and vent line
c. Ignition System
- Magneto ignition system
d. Miscellaneous items used in the above systems
- Connectors and assemblies
2. Length of Coverage
For a period of three years from date of original purchase, the
manufacturer warrants to the initial owner and each subsequent
purchaser that the engine is free from emission defects in materials
and workmanship that could cause the failure of the warranty part,
and that it is identical in all material respects to the engine described
in the manufacturer’s application for certication. For models 4000,
4400 and 5000 the emissions warranty is 175 hours or one year. The
warranty period begins on the date the engine is originally pur-
chased.
25 26