7MUDITA BELL - USER GUIDE
Factory reset
In the event that you experience any problems with the oper-
ation of the alarm clock, please try to do a hard reset of the
device. This may help to solve some of the issues.
If the problems are not resolved, please contact Mudita.
To reset the device, press the settings and light buttons simul-
taneously, for 5 seconds. Release when you hear a ring sound
and the light goes o.
NOTE: Instructions on how to do a reset can also be found on
the bottom part of the body of the alarm clock.
Technical data Input: DC: 5V/1A(5W)
Battery: 2600 mAh
Operating temperatures: 0°C to 40°C (32°F to 104°F)
PRESS THE SETTINGS AND LIGHT BUTTONS
SIMULTANEOUSLY, FOR 5 SECONDS.
WARRANTY
SAFETY AND USE
CHARGING
BATTERY SAFETY
REGULATORY
INFORMATION
DISPOSAL
FCC AND ISED
CANADA COMPLIANCE
For information about the consumer warranty, please refer to Mudita’s website:
www.mudita.com.
We recommend that you read this section very carefully before using the alarm clock. The manu-
facturer disclaims any liability for damage, which may result as a consequence of improper use
or use contrary to the instructions contained herein.
This alarm clock must be used with an AC power adapter that has been certified with a Limited
Power Source output per IEC 60950-1/62368-1 rated: 5 Volts DC, maximum 1.5 Amps.
Replace the battery according to the User Manual available on www.mudita.com. The lithium- ion
battery in this device should be serviced only by the manufacturer (Mudita), and must be recycled
or disposed of separately from household waste. Dispose of batteries according to your local envi-
ronmental laws and guidelines.
Regulatory and certification markings are included on this device.
This device complies with part 15 of the FCC Rules and ISED Canada license- exempt RSS stand-
ard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
The symbol on the device, the accessories or packaging indicates that this device must not be
treated as unsorted municipal waste, but must be collected separately. Dispose of the device via a
collection point intended for the recycling of electrical waste and electronic equipment within the
EU and in other European countries which operate separate collection systems for electrical waste
and electronic equipment. By disposing of the device in the proper manner, you help to avoid pos-
sible hazards for the environment and public health, which could otherwise be caused by improper
disposal of waste equipment. The recycling of materials contributes to the conservation of natural
resources. The device contains a battery. Batteries may not be disposed of with the usual domestic
waste. They may contain toxic heavy metals and are subject to hazardous waste regulations.
For this reason, dispose of the device at a local collection point intended for the recycling of elec-
trical waste and electronic equipment.
To Next Page