HOW TO MAKE COFFEE | 54 | OvERvIEW OF PARTS
OVERVIEW OF PARTS
Handle
Outlet/Gasket
Water Boiler
“On/Off”
Button
Brew Head
Filter
Capsule Holder
Dispenser
Drip Tray
BEFORE FIRST USE
Before you use your Single Serve
Coffee Maker for the first time,
perform an initial cleansing brew
by running clean water through the
brewing cycle without using
a capsule.
Add a mug on the Drip Tray to catch
the cleaning water. Afterwards, dump
the water and clean your mug.
NOTE: Mug and single use coffee capsules not included.
1 Place the Coffee Maker on
a flat surface and plug it into
a power outlet.
2 Lift the Brew Head by pulling
on the Handle.
3 Fill the Water Boiler with
the desired amount of
water (10 oz maximum) and
insert a capsule into the
Capsule Holder.
4 Place a mug under the
Dispenser on the Drip Tray.
Brewing into a tall
mug (up to 4.1 in)
To brew into a tall mug,
simply remove the
Drip Tray and place
the tall mug underneath
the Dispenser.
HOW TO MAKE COFFEE
NOTE: Do not remove the foil
cover or puncture the capsule.
CAUTION!
Avoid the sharp piercing pins located inside the Brew
Head and at the bottom of the Cap sule Holder.
To Next Page
Loading...
