CLEANINg THE CAPSULE HOLDER | 98 | CLEANINg ExTERNAL PARTS
Press the “On/Off”
button to start
cleaning. When
liquid starts to
dispense, press the
“On/Off” button again to turn the
appliance off. Allow the appliance
to sit for at least 30 minutes.
STEP 4
After 30 minutes, press
the “On/Off” button
to complete the brew
without a capsule. Empty
the contents of the mug
into the sink. Be careful as
contents may be hot!
STEP 5
Finally, the appliance needs to be cleaned with water to remove the
descaling solution. Fill the Water Boiler with 8 oz of bottled water, close
the Brew Head without adding a capsule, place a mug on the Drip
Tray Plate and perform a brew. You may need to perform additional
water rinse cycles if you notice any residual taste.
STEP 6
CLEANING EXTERNAL PARTS
IMPORTANT!
Make sure the Coffee Maker is unplugged before
cleaning. Regular cleaning of the Coffee Maker external
components is recom mended.
Clean Your Coffee Maker Regularly
To keep your Coffee Maker looking and performing its best, be sure to clean
the external and internal compo nents on a regular basis.
– Never immerse the appliance in water or other liquids.
– Clean the housing and all external parts with mild soap and a damp,
non-abrasive cloth.
– For the warming plate, use a clean, damp cloth. Never use rough, abrasive
materials or cleaners to clean the warming plate.
Drip Tray
The Drip Tray catches any liquid overflow. Slide
the Drip Tray toward you to remove it. To avoid
spilling, keep the Drip Tray level. Hand wash
the removable Drip Tray with warm, mild soap
and water. Allow to dry before reinserting it.
NOTE: Empty the Drip Tray before any long-term storage or inactivity.
CLEANING THE CAPSULE HOLDER
1 Lift the Handle to open the
Coffee Maker.
2 Grasp the top of the
Capsule Holder. Gently twist
counterclockwise to unlock it,
then pull straight up for removal.
3 Wash the Capsule Holder.
It is top rack dishwasher safe
or wash by hand with mild
soap and water.
4 Allow the Capsule Holder
to dry before reinserting it.
5 Reinserting is the reverse of
removal. Ensure you align the
Capsule Holder rib with the
recessed area in the Coffee
Maker when you insert it.
6 Give a gentle clockwise twist
until you hear the Capsule
Holder click into its locked
position.
CLEANING THE FILTER
1 Remove the Filter basket
by grasping its handle and
lifting straight up.
2 Wash the Filter in warm, soapy
water and rinse thoroughly.
3 After cleaning, replace the Filter
in the Filter holder and press
firmly to make sure it closes
securely.
To Next Page
Loading...
