Mueller Mi.Net - General Information; Components

2
MI.NET® MOBILE TRANSCEIVER
General Information / Components
The Mi.Net Mobile Transceiver is
capable of collecting meter data
in one-way mobile AMR system
from Hot Rod transmitters and
Mi.Node M transmitters. The
transceiver is also capable of
collecting and transmitting data in
a two-way mobile AMR system that
utilizes a combination of Hot Rod
transmitters and Mi.Node M units.
In AMR systems, the transceiver
captures water meter data via radio
frequency while driving a meter
route at posted speed limits. When
utilized in a Mi.Net AMI system, the
Mobile Transceiver is capable of
being used as a backup or primary
reading device in the event of
sustained power outages in parts
of or an entire system. It is capable
of receiving data and sending
messages to Mi.Node M devices.
OVERVIEW
The Mi.Net Mobile Transceiver ships
with the following, see Diagram 1:
1. Mi.Net Mobile Transceiver
2. 110 VAC to 12V adapter
3. 12V auxiliary transceiver power
cord (for vehicle)
4. Mi.Net Mobile antenna base
5. Mi.Net Mobile antenna (2 pieces)
with gasket
6. Mi.Net Mobile antenna cable
(connects transceiver to antenna)
7. USB 2.0 cable, Type B to Type A
(connects transceiver to laptop)
8. Quick Start Guide (this document)
9. Mi.Net M Install Tool
10. Mi.Net M Install Tool antenna
11. USB 2.0 cable, Type A to mini
(charges Install Tool)
12. Mi.Net M Install Tool User
Manual*
13. USB Flash Drive, 4GB
(used only for upgrades)
14. AC to DC Wall Power Adapter*
15. USB Filter*
*Not Pictured
Antenna
The Mi.Net Mobile Transceiver
connects to a magnetic mount
antenna mounted to the roof or
other area of your vehicle. The
antenna port is located at the back
of the unit at lower left.
HARDWARE COMPONENTS
5
7
4
6
1
9
3
11
136
10
2
DIAGRAM 1. MI.NET MOBILE TRANSCEIVER COMPONENTS