Mullen ONE - Page 6

To Next Page

To Previous Page

STEP TWO:

Access and disable low voltage electrical system located under the driver seat.

1. Lift the fore/aft lever and position the seat midway on its track.

2. Lift the recliner lever and bring the seat back forward and down fully.

3. Locate the seat latches at the front base of the seat.

4. Push in the orange tab while lifting on the seat latch until it is unfastened. The seat has two latches.

5. Flip the seat backward and ensure that it is secured, prior to accessing the 12-Volt battery.

6. Disconnect both the Positive and Negative terminals from the 12-Volt battery and insulate them from

accidental contact.

STEP THREE:

The MSD plug must be removed to disable the high-voltage system.

1. Locate the MSD plug on the front side of the high-voltage battery between the driver’s seat and mobile

office console or passenger’s seat.

2. Pull out the orange trigger, also known as the Connector Position Assurance located on the bottom of

the MSD.

3. Pull the black locking lever up to expose the release tab (1).

4. Press and hold the release tab inward (2).

5. Rotate the black locking lever up (3).

6. Pull straight out on the body of the MSD to remove it (4).

7. Wait a minimum 15 minutes to allow charges to dissipate.