Mullen ONE - Disabling High and Low Voltage Systems

To Next Page

To Previous Page

and organic solvents as the dominant active ingredient, absorbed in special polymeric film.

The electrolyte will not leak from the battery under most conditions. However, if the battery is

crushed, it is possible for a small amount of electrolyte to leak. Use proper clean-up procedures,

followed by flushing the impacted area with large amounts of water to clean up any leaked material.

FAILURE TO FOLLOW THESE INSTRUCTIONS MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.

Disabling High and Low Voltage Systems

Disable both low and high voltage electrical systems by following the instructions below:

STEP ONE:

Turn OFF the vehicle and remove the key from the ignition.

1. Confirm that the vehicle is at a standstill.

2. Ensure parking brake is securely engaged on level ground (“Park” telltale will illuminate to indicate

parking brake is engaged in the driver’s cluster).

3. Vehicle must be in the Neutral (N) gear position (“N” telltale will illuminate to indicate Neutral gear

position is engaged in the driver’s cluster).

4. Turn the key in the ignition to the “OFF” position and remove the key from the ignition.

5. Position wheel and tire chocks to prevent rolling or shifting of the vehicle.