If you don't know which protocol your system supports, you can test this by
selecting protocol “AUX2”. If you can then assign functions [➙ 10] for the
ISOBUS job computer to the joystick, your system supports Auxiliary 2.
Otherwise, select protocol “AUX1”.
To configure the joystick:
The terminal is switched off.
1. Hold button 2 on your joystick pressed down. You can recognize button 2 from
its white surround.
2. Start the terminal.
3. Release button 2 after approx. 5 seconds.
4. - Open the Joystick application.
5. Configure the joystick.
6. Restart the terminal.
To Next Page
Loading...