www.element14.com
www.farnell.com
www.newark.com
Page <6> V1.118/06/18
MC-I20 User Manual & Troubleshooting
3. Installation
a. Connect the power cord
b. Install extrusion line, guide tube and rack
c. Load material – when feeding, the material tray should rotate counter clockwise
4. Load material
a. All installations have been done well. “prepare” >> “change lament”
b. “Load”
Attention: When the material is unloaded, the material is quickly pulled out, otherwise the consumable material will be blocked.
c. When temperature reaches the pre-set temperature, extruder will move.
5. Adjust platform
Adjusting platform is very important. It has effect on the printing quality and success. Before your printing, when you have
adjusted the platform, the later cannot adjust platform.
a. “prepare”>> “Bed Auto Leveling”
To Next Page
Loading...