Need help?Do you have a question about the multicomp PRO Pi-4 and is the answer not in the manual?
General| Processor | Broadcom BCM2711, Quad core Cortex-A72 (ARM v8) 64-bit SoC @ 1.5GHz |
|---|---|
| Video Output | 2 × micro-HDMI ports (up to 4Kp60 supported) |
| RAM | 2GB, 4GB, or 8GB LPDDR4-3200 SDRAM (depending on model) |
| Connectivity | 2.4 GHz and 5.0 GHz IEEE 802.11ac wireless, Bluetooth 5.0, Gigabit Ethernet |
| Audio Output | 3.5mm audio jack |
| USB | 2 × USB 3.0 ports; 2 × USB 2.0 ports |
| GPIO | 40-pin GPIO header |
| Storage | MicroSD card slot for operating system and data storage |
| Power | 5V DC via USB-C connector (minimum 3A), 5V DC via GPIO header (minimum 3A) |
| Operating Temperature | 0 – 50 °C |
| Operating System | Raspberry Pi OS |
Warning regarding electrostatic sensitive devices and necessary grounding procedures during assembly.
Insert Pi board into casing and connect riser to header connector pins.
Clip support pillars and mount cooling fan into PCB cut-out, feeding wire through.
Route fan wiring, connect to PCB header, and clip PCB onto mounting pillars.
Lower the upper casing over the assembly until it snaps into place.
Install latest OS to SD card, update system via terminal commands.
Edit config.txt to add dtoverlay for power-off and shutdown control.
Note on using the upper USB socket for power supply to ensure button functionality.
Instructions for starting, shutting down, and forced shutdown using the STAND-BY button.
To Next Page