[
55
]
The Multifeeder Technology high speed labeling system allows the use of non standard product or
label sensors to meet specic application requirements. Follow the instructions below to connect
and enable the non standard product or label sensor. Follow the instructions specic to the sensor to
ensure the sensor function properly in your application.
1 Connect the non Standard Sensor to J3.
2 Navigate to the Advanced Sensor settings. From the READY screen on the controller, press the
key.
3
Press the to navigate to the Main 2/2 screen.
Continue on the next page.
Terms/Conditions
Maintenance
SafetyIntroduction Terminology Setup
To Next Page
Loading...