Instruction manual (Translation of the original instructions)
CM150032EN - 16.06.15 - 05 (11.07.18)
39/76
Self-moving Compact wheel loader, articulated frame, equipped with
multipurpose quick coupler, MULTIONE 6 Series
MultiOne SRL
7 PRE-START INSPECTION
WARNING
IT IS COMPULSORY, BEFORE THE FIRST STARTING OF THE MACHINE, TO EXECUTE THE FOLLOWING OPERATIONS.
Ref. Operations
1 Make sure the machine is undamaged in all its parts.
2 Check the integrity of safety system (belt, ROPS, etc.).
3 Check the engine oil level (see chap. 9).
4 Check the engine water level (see chap. 9).
5 Check the oil level of the hydraulic circuit (see chap. 9).
6 Restore the power supply circuit of the battery by acting on the battery disconnecting key (see par. 7.1).
7 Check the nipples and if necessary provide with greasing (see chap. 9).
8 Get used to the controls and their functions (see par. 4.3).
TAB. 19
7.1 Connecting / disconnecting battery
To restore the electrical connection of the battery proceed as follows:
1) Remove the cap from the hole in the battery switch.
2) Insert the special key (FIG. 18 - Ref. 1) into the battery switch and turn it clockwise.
To disconnect the battery, proceed as follows:
1) Turn the special disconnecting battery key (FIG. 18 - Ref. 1), counterclockwise and store it in a safe place.
2) Close the hole of the battery disconnecting key using the special cap.
FIG. 18
PRE-START INSPECTION -7
To Next Page
Loading...
Need help?
General
