Need help?Do you have a question about the Multiplex Alpina and is the answer not in the manual?
Gluing steel blades and locating pins into wing roots using slow-setting epoxy.
Sealing wing root slots with resin and ensuring proper curing.
Fitting tailplane tips and sanding them to shape.
Gluing rudder blocks and strip to the rudder for shaping.
Fitting the all-flying tailplane bellcrank into the fuselage fin.
Soldering couplers, fitting clevises, and checking pushrod linkages.
Setting wing dihedral angles using side pieces and brass tubes.
Gluing the wing joiner unit to the fuselage for structural integrity.
Installing servo plates and formers within the fuselage.
Assembling the canopy frame parts and fitting them to the fuselage.
Setting up aileron pushrods, bellcranks, and horns for free movement.
Fitting airbrake units, pushrods, and sealing components.
Sanding wings and tail, and applying covering or paint.
Connecting servos, receiver, and battery, and checking control surface movements.
Determining and adjusting the model's balance point for stable flight.
Trimming control surfaces and checking responses before the maiden flight.
To Next Page
General