8
[
BIG LIFT II # 21 4091
Examine your kit carefully!
MULTIPLEX model kits are subject to constant quality checks throughout the production process, and we sincerely hope that you are
completely satisfied with the contents of your kit. However, we would ask you to check all the parts before you start construction, as we
cannot exchange components which you have already worked on. If you find any part is not acceptable for any reason, we will readily
correct or exchange it. Just send the component to our Model Department. Please be sure to include the purchase receipt and a brief
description of the fault.
We are constantly working on improving our models, and for this reason we must reserve the right to change the kit contents in terms of
shape or dimensions of parts, technology, materials and fittings, without prior notification. Please understand that we cannot entertain
claims against us if the kit contents do not agree in every respect with the instructions and the illustrations.
Caution!
Radio-controlled models, and especially model aircraft, are by no means playthings. Building and operating them safely requires
a certain level of technical competence and manual skill, together with discipline and a responsible attitude at the flying field.
Errors and carelessness in building and flying the model can result in serious personal injury and damage to property. Since we,
as manufacturers, have no control over the construction, maintenance and operation of our products, we are obliged to take this
opportunity to point out these hazards and to emphasise your personal responsibility.
Additional items required:
For the electric and glow powered versions:
Receiving system (in the model)
Receiver:
MULTIPLEX Micro IPD receiver 35 MHz A-band Order No. 5 5971
or
MULTIPLEX Micro IPD receiver 35 MHz B-band Order No. 5 5970
or
MULTIPLEX RX-9 Synth DS IPD receiver 35 MHz A-band Order No. 5 5890
or
MULTIPLEX RX-9 Synth DS IPD receiver 35 MHz B-band Order No. 5 5900
Servos: MULTIPLEX Profi Digi, 6 (7) required Order No. 6 5374
Switch harness:
Switch harness with monitor Order No. 8 5046
Power system:
Internal combustion engine, approx. 15 - 32 cc * Electric motor: approx. 800 - 1200 W with gearbox.
Adhesives: cyano-acrylate (”cyano”) and activator; 5-minute epoxy, white glue
Use low-viscosity to medium-viscosity cyano glue, but only if the parts fit together snugly. Epoxy or white glue are suitable for most
wood - wood joints.
Tools:
Scissors, balsa knife, combination pliers, 1.5, 2, 3, 4 and 6.5 mm Ø twist drills, screwdrivers, small round file (3 mm Ø).
Specification:
Wingspan 2400 mm
Fuselage length 1620 mm
All-up weight, electric with 30 SC cells approx 5400 g
All-up weight, glow approx. 20 cc motor approx. 4900 g
Wing area approx. 84 dm²
Wing loading , Gas version (FAI) approx. 58 g/ dm²
RC functions Aileron, elevator, rudder and motor; optional aero-tow release
To Next Page
Loading...
