24. Replace the provided shaver belt reversing the
actions in Step 21. Tighten the belt by pulling
back on the motor before completely tightening
the hex head bolts. Motor should be positioned
at or near the previous placed reference mark.
25. Disconnect the water and CO supply lines.
26. Remove and replace the O-rings on both the
water and CO supply lines.
Add food grade lube to the O-rings before
reconnecting the water and CO supply lines.
27. Use a soft bristle brush to remove the dust, dirt,
and debris from the condenser coil.
28. Use shop vacuum to clean the condensate drain
pan.
29. Locate the condensate drain line.
Using a shop vacuum clean the condensate
drain line by applying suction to the outlet of
the drain line.
30. Remove both the top left and top right side panels.
31. Slowly pour hot tap water down the left side
and right side blend chamber drains, rinse area
drain and the ice bin drain.
Multiplex
2100 Future Drive
Sellersburg, IN 47172
Phone: 844-724-2273
Fax: 920-683-7592
Page 8 of 13
2020 Tune Up, continued
To Next Page
Loading...
