MULTISPAN CPR 126-1C - Page 3

Password
Over current
(Enable/Disable)
(Enable/Disable)
Press key for save & exit
Press key for save & exit
(Under Current)
Press key
Press key
Press key
Press key
Press key
SET
SET
SET
SET
SET
SET
SET
SET
SET
SET
SETSET
SET
p a s
1 1
O C
e n b
u C
e n b
Password
If over current is enable
If under current is enable
If over current
is disable
If under
current
is disable
Over current
(Over current value)
(0.00 - 125% of
primary C.T Value)
(0.00 - 100% of
primary C.T Value)
(Under current value)
(Under Current)
Press key
Press key
Press key
Press key
Press key
p a s
7 3
O C
5 0 0
5 0 0
u C
Enter password 73
Enter password 11
Press key
for 5 sec
SET
Press key
for 5 sec
NOTE :-
- If Auxiliary supply cut out without fault Reset, Then
fault will be display at next power on.
SET
- To Reset fault press key.
O C O C
R
3 4 5
R
Scroll
Over current
Value = 34.5 A
◘
U C
R
1 0 0
R
Scroll
Under current
Value = 10.0 A
◘
Password 11 : To Enable / Disable trip parameter
(Over current, Under current,
Asymmetry, Single phase prevention)
Password 73 : To set trip value of Over current,
Under current, Asymmetry percentage
Password 37 : To set Power on time, ITD, Trip delay time,
reset Mode,Relay Fault mode,Power Fail
Fault Memory ,C.T ratio
1 1
FAULT MESSAGE
PARAMETER SETTING
Page -3