https://munbyn.biz/130B-FAQ
Introduction
Destination Select
Installation Type
Installation
Summary
Install ITPP130Printer Verl.6.6
The installation was completed successfully.
The installation was successful.
The software was installed.
Close
Pro Tips
Anytime you change your label, run the automatic label identification.
Press the feeder button on the printer to skip a blank label
o To run a self-test, press and hold the feeder button until you hear two short
beeps.
• To ensure your printing quality, please use MUNBYN labels. fyou use other
brandsl label paper, please run "automatic label identification" before
printing.
Regularly c ean the printer head.
Ifthe paper is jammed and the red light flashes, run Automatic label
identification.
Insert Munbyn into the same USB port on your computer everytime.
This will avoid creating duplicate copies of the printer in your operating
system.
10
To Next Page
Loading...
