Munters EM50 - Centrifugal System and Pulley to Propeller Assembling

© Munters AB, 2018
17
Place the oval plate over support frame and then start
to screw the nuts.
Tighten the nuts with pneumatic screwdriver (ref.3/
Assembling tools) in order to fix the propeller central
support to the top and bottom panels.
Insert the electric motor (ref.4/Motor) into its slot
taking care to fix it over proper track on the top side.
Fix motor slide to top panel by means qty. 2 screws
and qty. 2 washers (ref.7.3/Bolts&nuts). Tighten
screws by using 13mm spanner (ref.10/Assembling
tools).
CENTRIFUGAL SYSTEM AND PULLEY TO PROPELLER ASSEMBLING
Place the pulley on the hub and insert the screws
(ref.7.5/Bolts&nuts).
Turn the pulley plus the hub upside down, insert
and fix the flanged nuts (ref.7.5/Bolts&nuts) over
the screws.
Assembling guidelinesChapter3