Need help?Do you have a question about the Murex Transtig AC/DC 205 and is the answer not in the manual?
Details on safe lifting, cylinder handling, glare, fire, and heat precautions.
Covers electrical hazards and critical safety cautions during operation.
Explains the different welding modes: DC Electrode Negative, AC, and DC Electrode Positive.
Procedure for connecting gas cylinders, regulators, and flowmeters.
Explanation of ON/OFF, HF, and Mode selection switches.
Details on Remote/Local switch, current control, AC balance, and slope controls.
Identifies common welding defects like porosity, undercut, and lack of penetration.
Specifies output voltage, current range, duty cycle, and input power ratings.
Covers initial checks for power supply, indicator lamps, and fuses.
Checks related to TIG mode, gas supply, torch, and electrode setup.
General| Input Voltage | 230 V |
|---|---|
| Input Frequency | 50/60 Hz |
| Open Circuit Voltage | 70 V |
| Duty Cycle | 60% |
| Type | Inverter |
| Duty Cycle (TIG) | 60% at 205 A |
| Welding Processes | TIG, MMA |
To Next Page
