Muse M15 - Page 12

Depending on which software you purchased with your Muse vinyl cutter,
there are two ways to set it up:
1.
2.
Place your Muse on a sturdy horizontal surface. Keep the area around the Muse free of clutter and
unnecessary items. This will prevent other objects from obstructing normal feeding of media through the
cutter. Impacts with items around the cutter can cause a material to lift o the platen or feed incorrectly.
Either of these can negatively impact cut quality and/or tracking.
To turn on the power for the M15 or M24, press the power button on the right end cap. For the M60,
ip the switch up on the left end cap.
The Muse will take a few seconds to power up. The LED light will come on and the tool carriage will engage.
REMEMBER: Once the cutter is on, do not move the tool carriage manually. This can damage
the tool carriage and/or main board. Use only the arrows on the control panel to move the tool carriage.
To power o your M15 or M24 cutter, press and hold the power button until the cutter powers down. On the
M60, ip the power switch down.
There are 3 ways that you can connect your Muse to the computer:
You may choose any one of these three connectivity options. You can also change from one to the other at
will, but for best results use one at a time. Here are the benets of each connectivity option:
You’ll nd complete step-by-step instructions on our Product Support
Blog for LXi. Please click here to access the setup tutorial or go to
https://techsupport.signwarehouse.com/
To install Create Space, download the software from the following
link (note there are separate links for Mac and Windows users). You
will also nd a video to assist you with installation and activation of
your registration number:
https://techsupport.signwarehouse.com/create-space-software-support-resources/
1.
2.
3.
1.
USB Cable
Wi-Fi
USB Flash Drive
The USB cable is the simplest and most reliable connection. Setup is quick and easy. See Sections 1.10.1
or 1.10.2 for instructions.
1.9 Registering and Installing the Design Software
1.10 Connecting the Muse to Your Computer