11.
12.
Once the camera has taken a photo on the left side,
tap the center of the test shape on the screen and
press OK. The camera will take over and locate the
center on its own.
Once the arrows appear, press the HOME button
and then press STOP on the Main Screen to save
the calibration and conclude the process.
The red + and the blue dashed + are still not aligned. You will need to tap the center again and press OK.
Continue, as needed, until the center is identied and the camera moves to the left side test shape and
takes a photo.
4.2 Setting Up Dual Head Applications on the M60
The M60 comes with a creasing tool (refer to Section 1.4) which can be used to score fold lines. Having the
second blade holder seat enables you to score and cut all in one process.
In general, the creasing tool works better if multiple passes are used at a moderate pressure versus using a
single pass at a very high pressure.
The following section shows how to set up a score and cut project in Create Space. Note that a similar setup is
used when utilizing both blade holders at once versus the creaser and a blade holder.
Score and Cut Project in Create Space
1.6.2
When a project involves both scoring and contour cutting, the layers need to be assigned appropriately on the
Layers Panel. There should be at least 2 layers: one for the fold lines, and a second for the cut lines.
Decide which head will have which tool mounted. In this example, the left will have the blade holder and the
right will have the creasing tool (but the opposite is ne, if you prefer).
Fig. 4.2.1
Fig. 4.1.5
Everything is
aligned with
the center
Press Home
To Next Page
Loading...
