There is a brake on each wheel.
Lift the cam up to engage the brake.
(fig D)
Push the cam level to release the brake.
(fig. E)
Your harp wheels include two straps.
The strap in front can go between the
pillar and the soundboard (fig. F)
OR it can just go over the feet. (fig. G)
The strap in back goes over the feet in back. (fig. H)
This may not be possible for your harp and that
is OK. The strap in front should be enough to lift
the platform up when you tilt the harp back.
Pull the straps tight for the best results. A little
wobble won’t hurt but the more secure your harp
is attached to the wheels, the better control you
will have as you move your harp around.
Once the harp is secured to the wheels, make sure
the brakes are off, tilt your harp back, and you are
off to the races. (fig. I)
USING THE BRAKES
USING THE WHEELS WITHOUT A CASE
FIG. D
FIG. F
FIG. E
FIG. G
FIG. H
FIG I
Brake is ON
OR
Brake is OFF
Musicmakers
14525 61st ST CT N
Stillwater, MN 55082
cam
To Previous Page
Loading...