Need help?Do you have a question about the Musway M4 and is the answer not in the manual?
General| voltage | 8 - 15 VDC |
|---|---|
| switched off current | <0.1 mA |
| consumption at 14.4 VDC 2Ω max musical power | 20A |
| remote IN voltage | 8 - 15 VDC |
| remote IN current | 1 mA |
| remote OUT voltage | 8 - 15 VDC |
| remote OUT current | 200 mA |
| fuse | 20 A |
| distortion - THD (1kHz @ 4Ω, 90% power) | 0.05 % |
| bandwidth (-3 dB, 2 V RMS, 4Ω) | 15Hz-22k Hz |
| S/N ratio @ A weighted, 1V, max power | 95 dB A |
| damping factor @ 1 kHz, 2 V RMS, 4Ω | >70 |
| crossover frequency | 1Hz step @ 20 - 20k Hz |
| output equalizer | 31Band Parametrics Equalizers: ±12 dB |
| time alignment distance | 0 - 346 cm / 0 - 136 in |
| time alignment delay | 0 - 10 ms |
| time alignment step | 0.02 ms; 2.8 cm / 1.1 in |
| time alignment fine set | 0.02 ms; 0.7 cm / 0.27 in |
| input sensitivity (Hi-level) | 5 V RMS |
| input sensitivity (line-level) | 0.5V RMS |
| PC connections | Micro USB (1.1 / 2.0 / 3.0) |
| graphic card min. resolution | 1024x 768 |
| ambient operating temperature range | 0 °C to 55 °C (32°F to 131°F) |
| input impedance (High-level) | 13Ω |
| input impedance (Line-level) | 47K |
| 4Ch @ 4Ω | 55W x 4 |
| 4Ch @ 2Ω | 70W x 4 |
| 2Ch - (Bridge 1/2; 3/4;) @ 4Ω | 150W x 2 |
| 4Ch @ 4Ω (10% THD) | 75W x 6 |
| 4Ch @ 2Ω (10% THD) | 85W x 6 |
| 2Ch - (Bridge 1/2; 3/4;) @ 4Ω (10% THD) | 170W x 2 |
| RCA Pre-Out | 4V RMS Max |
Weight and Dimensions| max size | 165 x 150 x 41 mm |
|---|---|
| net weight | 1.5 kg |
Performance metrics like distortion, bandwidth, and output power.
Filter types and slopes for audio signal division.
Parametric equalizer settings for audio tuning.
Controls speaker arrival time based on distance.
Type of USB connection for PC interface.
To Next Page
