About Beads
Once upon a time there was Clouds. Then came the day to
clean up the mess.
Beads is a granular audio processor. It creates textures and
soundscapes by playing back layered, delayed, transposed
and enveloped fragments of sound (“grains”) taken continu-
ously from the incoming audio signal.
Installation
Beads requires a -12V/+12V power supply (2x5 pin connec-
tor). The red stripe of the ribbon cable (-12V side) must be
oriented on the same side as the “Red stripe” marking on
the module and on your power distribution board.
The module draws 100mA from the +12V rail, and 10mA
from the -12V rail.
Online manual and help
The full manual can be found online at
mutable-instruments.net/modules/beads/manual
For help and discussions, head to
mutable-instruments.net/forum
Please refer to the online manual for detailed infor-
mation regarding compliance with EMC directives
To Next Page
Loading...
