15
THE DISHWASHER DOES NOT
WORK ?
1- Verify the main water supply inlet
is correctly connected, open and
free from any obstructions.
2- Verify main electrical supply is
working without any electrical break in
connection.
3- Verify the door is properly closed.
DISHWASHER DOES NOT WASH
WELL ?
1- Verify the filters are clean, if not,
clean them. (see par. 3D4)
2- Verify the washing water jets on the
washing arms are not obstructed by
any solid residue.
3- Verify the correct amount and quality
of detergent and rinse aid. (see par.
3B2/3C2)
4- Verify the dishes are correctly
loaded in the dishwasher. (see par.
3B6/3C7)
5- Washing cycle is too short. Use
another cycle (if available) or repeat
the washing cycle.
THE DISHES ARE NOT RINSED WELL?
1-
2-
Verify the rinse water jets on the
washing arms are not obstructed by
any solid residue.
Verify solenoid valve filter is free from
any obstructions such as lime or scale.
Verify the inlet water pressure is more
than 29psi, if not install an external
pressure device to increase the
inlet water pressure inside the
machine.
THE DISHES ARE NOT DRIED WELL ?
1- Ask the rinse aid supplier to verify the
instructions for the rinse aid dosing.
(see par. 2D)
2- Verify if the rinse aid container is
empty. If yes, fill it with rinse aid
product. (see par. 2D)
3- Verify the quality and the quantity of
the rinse aid used and check with the
supplier. (see par. 2D)
4- Verify the rinsing temperature is
between 80°C (176°F) to 90°C (194°F)
degrees.
CONDENSATION ON GLASSES ?
1- Verify if the rinse aid container is
empty. If yes, fill it with rinse aid
product. (see par. 2D)
2- Verify the quality and the quantity of
the rinse aid used and check with the
supplier. (see par. 2D)
3- Remove the glass rack immediately
after the end of each cycle.
STAINS ON GLASSES ?
1- Use only non foaming products for
professional dishwashers.
EXCESSIVE FOAM IN THE TANK ?
1- Verify washing water temperature is
not less than 50°C (122°F) degrees.
2- Ask the supplier to verify the instruction
for the rinse aid dosing.(see par. 2D)
3- Ensure the tank has not been cleaned
with an unsuitable cleaner. Drain the
tank and rinse throughly before a new
wash cycle.
4- If foaming detergent has been used,
drain and refill the tank with water
until the foam disappears.
SMEARS OR SPOTS ON THE GLASSES ?
1- Ask the supplier to verify the
instruction for the rinse aid dosing.
EMERGENCY
IN CASE OF FIRE A POWDER
EXTINGUISHER MUST BE USED.
IN CASE OF DANGER CUT-OFF THE
ELECTRICAL SUPPLY IMMEDIATELY.
The Manufacturer reserves the right to
modify the data presented in
this publication without prior notice.
3-
To Next Page
Loading...