EasyManua.ls Logo

MVP SPRINT - First Generation Operating Information

MVP SPRINT
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
The battery is expected to last between two (2) and five (5) hours depending upon the type,
frequency and duration of drills between charges.
Once a batterys charge has been completely used, it will need to be plugged into its charger. The
charger will recharge the battery in approximately six (6) hours.
MVP | SPRINT will beep if left idle for five (5) minutes. This is a reminder to turn off your dummy
at the end of each session. You can silence the beep and restart the five-minute idle time by
turning the MVP | SPRINT in place.
If MVP | SPRINT slows down it is at the end of its charge cycle and the battery is near empty. Use
the remaining battery charge to drive the unit to its charger.
Turn off MVP | SPRINT when not in use to avoid serious damage to the battery and to avoid
wasting the current charge on the battery. If the MVP | SPRINT beeps due to being left idle, turn
off the MVP | SPRINT.
To prolong battery longevity, see Battery Use, Storage, and Charging Instructions.
Do not attempt to use the MVP | SPRINT more than 200 yards from the controller.
If planning to store the MVP | SPRINT for more than seven days see Battery Use, Storage, and
Charging instructions.
General Operating Information