11
The battery is expected to last between two (2) and five (5) hours of intermittent use depending upon the
type, frequency and duration of drills.
If the MVP | SPRINT stops, check the battery indicator lights on the internal control panel (under the flap
on the cover of the MVP |SPRINT). The dummy will stop if the battery runs down or if the MVP | SPRINT
overheats. If the Over Temp light is lit, let the unit sit for 20-30 minutes to cool.
▪ Once a battery’s charge has been completely used, the dummy will enter “slow mode” and only
operate at a reduced speed. It will need to be plugged into its charger. The charger will recharge
the battery in approximately six (6) hours.
▪ Plug the Charger 3 pin DC output cable into the charger first, then plug the charger AC power
cable into the wall outlet.
▪ The LED will be RED to indicate charging. NOTE: the charger fan will run intermittently as required
during the charging process.
▪ The LED will turn Green when charge is complete
▪ Charging your MVP | DRIVE from an empty battery to a full charge should take approximately 6
hours.
▪ Fully charge battery (charger indicator light is Green)
▪ Run MVP | SPRINT dummy until only two of the battery charge indicator LED’s are illuminated
(located on the internal control panel). Be sure to turn off the power switch.
▪ Remove the AA batteries from controller to prevent damage due to battery leakage.
▪ Store unit on the storage block provided in the original shipping box to lift wheels off floor.
▪ Store your dummy and charger in a dry, moderate temperature environment (~70°F). Very hot
temperatures, very cold temperatures or significant moisture in the storage environment can
damage the battery or reduce its life.
▪ Battery can explode if damaged, punctured, or disposed of in fire.
▪ Never disassemble or modify pack wiring in any way or puncture battery.
▪ If reduced dummy run time is experienced, or if charger stops functioning please email:
info@mvprobotics.com
To Next Page
Loading...