11
The battery is expected to last between two (2) and five (5) hours of intermittent use depending upon the
type, frequency and duration of drills. If the MVP | SPRINT stops, check the battery indicator lights on the
internal control panel (under the flap on the cover of the MVP |SPRINT). The dummy will stop if the
battery runs down or if the MVP | SPRINT overheats. If the Over Temp light is lit, let the unit sit for 20-30
minutes to cool.
▪ Once a battery’s charge has been completely used, the dummy will enter “slow mode” and only
operate at a reduced speed. It will need to be plugged into its charger. The charger will recharge
the battery in approximately six (6) hours.
▪ Plug the Charger 3 pin DC output cable into the charger first, then plug the charger AC power
cable into the wall outlet.
▪ The LED will be RED to indicate charging. NOTE: the charger fan will run intermittently as
required during the charging process.
▪ The LED will turn Green when charge is complete
▪ Charging your MVP | SPRINT from an empty battery to a full charge may take up to 6 hours.
▪ Thoroughly inspect your MVP|SPRINT for any signs of damage or excessive wear
▪ Clean/remove any buildup of dirt or grass
▪ Fully charge the battery (charger indicator light is Green)
▪ Remove the AA batteries from the controller to prevent damage due to battery leakage.
▪ Store unit on the storage block provided in the original shipping box to lift wheels off the floor.
▪ Store your dummy and charger in a dry, moderate temperature environment (~70°F). Very hot
temperatures, very cold temperatures, or significant moisture in the storage environment can
damage the battery or reduce its life.
1. Replace the old batteries in the controller with new AA batteries
2. Ensure controller settings align with manual (photo attached for reference)
3. Ensure no torn seams or zipper damage
4. With the unit powered off, tip the dummy on its front and ensure all 4 rollers and both wheels
spin freely
5. Ensure no damage to the foam or portion of the cover that goes beneath the unit
6. Fully charge your SPRINT prior to using after storage
▪ Battery can explode if damaged, punctured, or disposed of in fire.
▪ Never disassemble or modify pack wiring in any way or puncture battery.
▪ If reduced dummy run time is experienced, or if charger stops functioning, please email:
info@mvprobotics.com
To Next Page
Loading...