Reason #1: The battery is low
While the MVP | SPRINT is on:
5. Open the flap
6. Check to see if the low battery light is on
• If the low battery light is on:
3. Remove the MVP | SPRINT from the training session
4. Plug the MVP | SPRINT into the charger to avoid damaging the battery
(a full recharge will take approx. 6 hours)
7. If the battery is not low check reason #2
8. For more information on the battery see page 8
Reason #2: The motors are overheating and are going into safe mode until it cools down
While the MVP | SPRINT is on:
3. Open the flap
4. Check to see if the heat sensor light is on
• If the heat sensor light is on:
4. Remove the MVP | SPRINT from the training session
5. Relocate the MVP | SPRINT to a cool location (indoors or in the shade)
6. Turn off the MVP | SPRINT & allow to cool down
Your MVP | SPRINT does not respond to commands from the remote controller.
Reason: The controller is not on or is out of batteries. Replace the AA batteries in the bottom of the controller
Your MVP | SPRINT is driving in reverse or turning the wrong way?
Reason: The reverse toggle switch under the clear plastic on the side of the remote flipped to the opposite incorrect
side: Try switching it to the opposite side
Your MVP|SPRINT is turning very slowly?
Reason #1: The steering dual rate knob is not turned all the way clockwise: Turn it all the way clockwise if it is not.
Reason #2: The foam ring on the steering wheel is loose or off track: Ensure the foam ring is fully secure and fitting
properly on the steering wheel. You may need to grip the steering wheel harder
Your MVP|SPRINT drifts when driving?
Reason #1: The Trim knobs are not in the correct position: Ensure the trim knobs are centered
(If the trim knobs are centered and your MVP|SPRINT still drifts)
Reason #2: The calibration is off: Follow calibration procedure:
Calibration Procedure:
1. Lift the MVP|SPRINT wheels off the ground by placing it securely on an elevated object (4x4s work well)
2. Turn on the remote controller
3. Push the “cal” button the MVP|SPRINT using a long, thin object. The MVP|SPRINT will beep once.
4. Move the steering wheel and the throttle trigger back and forth to their limits until the MVP|SPRINT beeps a
second time.
5. Do not touch the remote controller for several seconds until the MVP|SPRINT beeps a third time
6. Calibration is now complete
To Next Page
Loading...