Mx Onda MX-PI2633FLEX - Error Messages

18
The hob produces a
humming noise
when used at a high
power level.
This is caused by
induction cooking
technology.
This is normal, the noise should be reduced or
disappear completely when the power is
decreased.
Fans noise coming
from the induction
hob.
The fans that cools the
induction hob has
turned on.
Prevent the hob from
overheating, the fans
can continue to work
after turning off the
induction hob.
This is normal and is not a malfunction. Do not
turn off the power to the induction hob while
the fan is running.
The containers do
not heat up and
the display shows
The cookware is not
suitable for induction,
the base of the cooker
is too small or it is not
centered on the
cooking zone.
Use cookware suitable for induction, with a
base large enough to be detected and center it
in the cooking zone
ERROR MESSAGES
If an abnormality arises, the induction hob will enter the protection state
automatically and display the corresponding error codes:
Message
Description
Solution
E 1 / E 2
Protection against under voltage (<85
V) or over voltage (> 285 V)
If the voltage at the mains outlet is lower or
higher than specified, consult a qualified
electrician.
E 3
Induction coil temperature sensor
fault.
Contact the closest MX ONDA Official
Technical Service.
E 4
IGBT temperature sensor failure
Contact the closest MX ONDA Official
Technical Service.
E 5
High temperature (> 280 ºC) of the
induction coil temperature sensor.
Turn off the induction hob and wait for it to
cool down.
E 6
High temperature at IGBT sensor
Check that the ventilation is correct and the
fans are not obstructed.
E r
Internal fault of the control circuits.
Contact the closest MX ONDA Official
Technical Service.
E E
There is excess liquid on the buttons
on the control panel
Clean and dry the control panel