- 32 -
Follow above wiring guidelines.
IMPORTANT: If you are experiencing
any issues with collars beeping or
vibrating randomly when they are not
near the wire perimeter, this may be an
interference issue caused by your
perimeter setup and you need to add a
resistor unit as per instructions below to
rectify the situation:-
Make certain you are using Min 80m/262
Feet of wire in you Perimeter Boundary.
If you have small perimeter, this may
cause inference and cause collars to
beep/vibrate randomly within the perimeter.
In that case, connect the resistor unit found
in your pack to one end of the Wire
To Next Page
Loading...