MYERSON FlexPress - Page 12

13. Place the ask onto the myerson Flexpress™, centering the sprue
hole of the ask over the center of the heating chamber. Lock the
ask in place using the ask strap and knobs.
14. When the timer expires, the myerson Flexpress™ will automatically
inject the myerson DuraFlex cartridge. The piston will stay in the up
position according to the hold time. Once the piston retracts, it is
safe to unscrew the hold down plate and remove the ask.
15. To remove the ask, loosen the hold down knobs and remove the
ask strap. Using heat resistant gloves, grasp the ask and press
the EXTEND/RETRACT button (lower right button). This will extend
the piston and push the crushed cartridge and ask out.
16. Press the EXTEND/RETRACT button again to retract the piston.
The myerson Flexpress™ is now ready for another injection.
17. After the appliance is divested, it can be placed in a stone remover
to eliminate any extra stone that is adhering to the appliance.
Notice how the Thermoplastic Model Separator MS-0200 has
created a smooth, clean surface on the underside of the appliance.
12