Section 8 ~ myerson DurAcetal
framework injection procedure
The following procedure outlines the steps necessary to create myerson
DurAcetal
®
frameworks with the myerson Flexpress™ Digital Injection
System.
1. Block out the saddles on the model. This is in preparation for the
acrylic that will be placed later. The thickness used is 1 to 1.5 mm
thick. You will notice the large tissue stop cut out of the wax.
Stability is the reason for the large tissue stop.
2. Below is the duplicated model. This model has been duplicated
using myerson Universal Stone UNISTONE-25LB.
The expansion stone accounts for the shrinkage that occurs
when myerson DurAcetal cools.
3. Place myerson’s Thermoplastic Model Separator MS-0200
on the duplicated model.
14
To Next Page
Loading...