DOC: OM-MYLIFE-19 My Life Hot Tubs
SPA SUPPORT
Whatever the support is, it must be:
a) A continuous, level surface, above grade, capable of handling 80 lbs. per sq. ft. that will not be compromised
by changes in the water table or water sitting in the area.
b) Such that the weight of the spa, water and bathers is not supported by the spa lip.
c) In full contact with the bottom of the spa
ACCEPTABLE SPA SUPPORT BASES
Concrete Pad 4" to 6" thick with provision for run off
Patio Stones, Pavers etc. Levelled with proper preparation of the earth
Wooden Deck Floor Incl. centre support uprights in concrete and joists spaced 12" on centre
Engineered Plastic Spa Pad Following pad manufacturer's instructions
Unacceptable Spa support bases include crushed gravel, stone dust, bare earth, platform built directly onto earth.
Damage caused by improper spa installation will void factory warranty.
Do NOT locate your spa in a low run-off area since melting snow or rain can cause pump and equipment damage.
WATER SHOULD ALWAYS DRAIN AWAY FROM THE SPA.
See next page for dimensions that can be used to determine the proper location of submerged conduits in concrete
slab installations. All dimensions are made from the outside of the spa's frame with the access panels removed.
To Next Page
Loading...
Need help?
General
