DOC: OM-MYLIFE-19 My Life Hot Tubs
READ AND FOLLOW ALL INSTRUCTIONS
When using this equipment, basic safety precautions should always be followed. Including the following:
a) A green coloured terminal or a terminal marked G, GR, Ground, Grounding or the international grounding
symbol is located inside the supply terminal box or compartment. To reduce the risk of electric shock, this
terminal must be connected to the grounding means provided in the electric supply service panel with a
continuous copper wire equivalent in size to the circuit conductors supplying this equipment.
b) At least two lugs marked "BONDING LUGS" are provided on the external surface or on the inside of the
supply terminal box or compartment. To reduce the risk of electric shock, connect the local common bonding
grid in area of the hot tub or spa to these terminals with an insulated or bare copper conductor not smaller
than No.6 AWG.
c) All field-installed metal components such as rails, ladders, drains or other similar hardware within 3m (10ft)
of the spa or hot tub shall be bonded to the equipment grounding bus with copper conductors not smaller
than No.6 AWG.
DO NOT connect your spa to an extension cord.
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
Hyperthermia
Prolonged immersion in hot water may induce hyperthermia. Hyperthermia occurs when the internal temperature of
the body reaches a level several degrees above the normal body temperature of 37°C (98°F). The symptoms of
hyperthermia include drowsiness, lethargy, and an increase in the internal temperature of the body. The effects of
hyperthermia include:
• Unawareness of impending hazard
• Failure to perceive heat
• Failure to recognize the need to exit spa
• Physical inability to exit spa
• Fetal damage in pregnant women
• Unconsciousness and danger of drowning
The use of alcohol, drugs or medication can significantly
increase the risk of fetal hyperthermia.
To Next Page
Loading...
Need help?
General
