MyTek Brooklyn AMP - USB Connectivity; Firmware Update Procedure; Technical Specifications

8 Mytek Brooklyn AMP User’s Manual 9
7. USB
Brooklyn AMP can be controlled by using Mytek Control Panel application. To downlad and install the
software please visit our support page: https://mytekdigital.com/hi/support/
8. Firmware update Windows and OS X
The current revision of the Brooklyn AMP rmware is shown in the MytekControl „General” tab.
• The rmware can be updated by using USB2 port and Mytek Control Panel application. It does not
require installed USB2 driver (PC). To download the current rmware please visit:
mytekdigital.com
Follow the steps below to update the rmware:
1. Download the latest rmware (*.mfb) le from mytekdigital.com
2. Click „Load rmware le” button and browse to the new rmware le then click „Open”.
3. Press the „Update” button to conrm uploading the rmware le to device’s memory.
4. Conrm your choice by clicking „Yes” when warning dialog appears. A progress bar will indicate
when the ash process is nished.
5. When the update is nished the the AMP will be switched off. To switch it on press the button on
the front panel once.
9. Technical Specication
Output Power in stereo and bi-amp mode,1kHz @ 8, 4, 2 Ohm: 2x 300W
Output Power in bridge mode, 1kHz @ 8, 4Ohm: 1x 600W
Burst Output Power in stereo and biamp, 1kHz @ 8, 4, 2 Ohm: 2x 500W
Burst Output Power in bridge mode, 1kHz @ 8, 4 Ohm: 1x 1000W
Output voltage in stereo and biamp mode: 70Vp/140Vpp unloaded
Output voltage in bridge mode: 140Vp/280Vpp unloaded
Frequency Response -3dB: 10 Hz - 30 kHz: +0/-0.25 dB
Upper bandwidth @ -3dB for RL = 8 Ohm: 85kHz
Upper bandwidth @ -3dB for RL = 4 Ohm: 65kHz
Upper bandwidth @ -3dB for RL = 2 Ohm: 44kHz
THD+N (1kHz @ 1W): 0.002 %
THD+N (typical): < 0.04 % (20 Hz - 20 kHz, 8 Ohm load, 3 dB below rated power)
Signal To Noise-Ratio: > 121 dB (A-weighted, 20 Hz - 20 kHz, 8 Ohm load)
Input gain control: 23dB (default), 29dB dip switch selectable
Input Impedance: 10 kOhm
Operation Voltage Universal Mains: 85-265V
Protection Circuits: short circuit protection, DC protection,
under voltage protection, temperature protection, overload protection
Dimensions: WxDxH:8.5x9.5x1.74” / 216x241x44mm
Weight: 6lbs / 3 kg
Warranty: 2 years