N-Com B802 User Manual

EN
14
F. Reset
In order to restore the factory settings of the device, press the “” or “” key until you hear the
voice message “
Factory Reset ”.
Press the “n” confirmation key to restore all the factory settings of the device.
G. Exiting the configuration
To exit the “Configuration” menu, press the “” or “” key until you hear the voice
announcement “ Exit the configuration ”.
Press the “n” confirmation key to exit the “Configuration” menu.
If no key is pressed within 15 seconds, the device automatically exits the “Configuration” menu.
8. MOBILE PHONE / MP3 PLAYER PAIR UP
 Make sure the B802 is turned off.
 Put the system in the “Pairing up” menu: press the “n” key and keep it pressed for 4 seconds, until
you hear the voice announcement “ Pairing up Menu ”.
 Press the “” key to access the “Mobile phone pair up mode”.
 Activate the search of Bluetooth devices on the mobile phone.
 Select the N-Com device. If a password is requested, enter 0000 (four zeros).
 Connection between the two devices is established after a few seconds.
N.B.: the affiliation is stored in the helmet and in the cell phone and it is not lost when the two
devices are turned off. As a result, it needs to be carried out only once.
Automatic Connection
Once the Bluetooth device has been paired up, connection is automatic
when the system is turned on.
Manual Connection
In case connection is not automatically initiated after a few seconds, you
can connect from the Bluetooth device or by pressing “n” and keeping it
pressed for about 2 seconds.
9. SECOND MOBILE PHONE PAIR UP
The B802 system can be hooked up to two phones at the same time. The second phone (secondary
device) can receive calls but not make them.
To pair up the second Bluetooth phone (secondary device):
 Make sure the B802 is turned off.
 Put the system in the “Pairing up” menu: press the “n” key and keep it pressed for 4 seconds, until
you hear the voice announcement “
Pairing up Menu ”.
 Press the “”key until you reach the option “ Second mobile phone pairing ”.
 Activate the search of Bluetooth devices on the mobile phone.
 Select the N-Com system from the list. If a password is requested, enter the code 0000 (four
zeros).
 After a few seconds, the connection between the two devices is activated.
N.B.: the affiliation is stored in the helmet and in the cell phone and it is not lost when the two
devices are turned off. As a result it needs to be carried out only once.

N-Com B802 Specifications

General

Brand	N-Com
Model	B802
Category	Motorcycle Accessories
Language	English