N-Com B802 User Manual

EN
24
Note: the “
Universal Conference ” mode can also be used by connecting only “800”/“900” series N-
Com systems”.
Note: the “ Universal Conference ” mode can also be used by connecting “800”/“900” series N-Com
systems with an N-Com system from a different or previous range.
16. REMOTE CONTROL
The B802 device can be controlled by using a remote control (sold separately), so that you do not
have to take your hands off the handlebars to use the keypad.
The N-Com system is compatible with the RC4 Remote Control by SENA.
The following table shows the equivalent keys:
N-COM SYSTEM


n
SENA RC4 + - CENTRAL KEY
Proceed as follows to pair up the N-Com system to the RC4 Remote Control:
 Make sure the RC4 is switched off.
 Put the RC4 in pair up mode: press the “+” key and keep it pressed for about 8 seconds.
 Make sure the B802 is switched off.
 Put the B802 system in the “Pairing up” menu: press the “n” key and keep it pressed for 4 seconds,
until you hear the voice announcement “
Pairing up Menu ”.
 Press the “” key to access the “Remote control pair up” mode.
 Press the “n” key on the N-Com system keypad.
 After a few seconds, the connection between the two devices is confirmed by the voice
announcement “ Remote control connected ”.
N.B.: the connection is saved by both the helmet and the remote control and it is not lost when the
two systems are turned off. Hence this procedure need only be carried out once.
Thereafter, the connection between the N-Com system and the remote control can be established by
briefly pressing the central RC4 key.

N-Com B802 Specifications

General

Brand	N-Com
Model	B802
Category	Motorcycle Accessories
Language	English