N1C LR Series - Page 6

Termination
Cable
RJ11 shorting plug
4.2. Install the short RJ11 Termination Cable in to one of the Extension Ports on the back of
the battery module.
4.3. Set the DC source with a constant current (CC): 15A; Constant voltage (CV): 52.5; then
turn off the DC source output.
4.4. Connect the DC source +/- outputs to the CON 1 port on the back of the battery
module.
4.5. Turn the breaker on the battery module ON (lift up).
4.6. Press and hold the button on the front of the battery module for 5s to wake the
battery module.
4.7. Turn ON the DC power source, then charge the battery to the desired SOC.
4.8. Disconnect the battery and DC source and turn off the breaker on the battery module.
5. Charge and discharge with Integrated Equipment
5.1. Equipment List:
Equipment
Type / Rating requirement
Comments
Charge/Discharge
Integrated Equipment
CE-6008n-60V50A-H
Termination Cable
RJ11 shorting plug