Need help?Do you have a question about the NAD 3150 and is the answer not in the manual?
Procedure for setting DC offset for amplifier channels.
Procedure for setting idle current for amplifier channels.
Alignment procedure for the FM Multiplex section.
Alignment procedure for the AM tuner section.
Procedure for setting DC offset for amplifier channels.
Procedure for setting idle current for amplifier channels.
Alignment procedure for the FM Multiplex section.
Alignment procedure for the AM tuner section.
General| Frequency Response | 20Hz to 20kHz |
|---|---|
| Damping Factor | 50 |
| Total Harmonic Distortion | 0.03% |
| Signal to Noise Ratio | 95dB (line) |
| Dimensions | 420 x 96 x 240mm |
| Speaker Load Impedance | 4Ω |
| Input Impedance | 47kΩ |
| Power Output | 50 watts per channel into 8 ohms (stereo) |
To Next Page
