BATTERY INSERTION PROCEDURE
1 Insert a hooked tip into the battery door release hole.
2 Slide out the battery tray.
3 Place the supplied CR2025 battery into the tray. Ensure the "+" symbol is
facing upwards.
4 Slide the tray back until it clicks into place.
REMOTE CONTROL
1 ON: Switch D7050 from Standby mode to operating mode.
2 OFF: Switch D7050 to standby mode.
3 +/- : Increase or decrease audio level.
4 t u : Select source.
5 Applicable for Airplay mode and for Tuner Controls of NAD products
with Tuner section
AIRPLAY MODE
]: Pause or resume playback of current song; if applicable, pause or
resume broadcast.
For Apple devices, allow 10 seconds delay before pressing ] again to
resume playback.
9: Skip backward to previous song; if applicable, scan backward
through current broadcast.
0: Skip forward to next song; if applicable, scan forward through
current broadcast.
TUNER CONTROLS (Not applicable for D7050; Applicable for
NAD products with Tuner section)
9 0: Step up or down Presets.
]: Select through applicable Tuner bands.
IDENTIFICATION OF CONTROLS
1
3
2
5
4
9
To Next Page
Loading...
