GB
18
RECORDING
Recordings Chapter 3
MANUAL RECORDING (FROM EXTERNAL SOURCE)
The recording can be started and paused at will.
1 Press INPUT on the front panel or the remote control repeatedly until the desired input is
displayed With each press of the button, the input changes as shown in the diagram on the left.
2 Load a blank or non-finalized CD-R/RW disc on the record tray.
3 Press AUTO/MANUAL on the remote control to select how tracks will be numbered on the
recorded disc See page 19 for details.
4 Press RECORD on the front panel or press REC on the remote control “RECORD” will flash, and
“BUSY” will briefly appear. When the display returns to the track and running-time information, the
unit is ready to record.
5 Play the source device.
6 Press PLAY on the record deck. Alternatively, press CD REC and then PLAY on the remote
control “RECORD” will stop flashing and the recording will be started.
TO STOP THE RECORDING
Press STOP on the record deck.
Alternatively, press CD REC and then PAUSE on the remote control. “BUSY” and “UPDATE” will be
displayed briefly.
TO PAUSE THE RECORDING
Press PAUSE on the record deck.
Alternatively, press CD REC and then PAUSE on the remote control.
To resume recording, press PLAY on the record deck.
Alternatively, press CD REC and then PLAY on the remote control.
TO PLAY OTHER MACHINES
As with all recorded CD-R/RW discs, the disc must be finalized before it can be played in other machines.
See page 20 for details.
NOTE
• It is possible to listen to the sound while recording by selecting the appropriate input on your receiver,
preamp or processor.
To Next Page
Loading...
