NAD T 758 - ZR 7 Remote Control for Zone 2

14 AUDIO PRE-OUT
• The AUDIO PRE- OUT makes it possible to use the T 758 as a pre-
amplier to external power ampliers for some or all channels.
Connect FRONT L, FRONT R, CENTER, SURR R, SURR L, SURR-BL and
SURR-BR to the respective channel input of a power amplier or
ampliers driving the corresponding applicable speakers.
• Unlike the full range channels, there is no power amplier built-into
the T 758 for a subwoofer. Connect the SUBW output to powered
(“active”) subwoofers or to power amplier channels driving a
passive system.
ZONE 2
• SURR-BL and SURR-BR are also assigned as secondary ZONE 2 OUT.
This is applicable only if “Zone 2” is the selected setting of “Back
Amp” in the “Amplier Setup” menu. For further information, refer
to the item about ZONE CONTROLS at the USING THE T 758 - MAIN
MENU segment of the OPERATION section.
• Refer also to the item about ZONE 2 AT AUDIO PRE-OUT SURROUND
BACK in the ZONE CONTROLS segment of the OPERATION - USING
THE T 758 - MAIN MENU section.
NOTE
Never connect both the external amplier and T 758’s speaker outputs to
the same set of speakers.
15 ZONE 2
• Send zone selected audio source to the corresponding audio input
of a separately located additional amplier or receiver (not supplied)
that can power its matching set of speakers.
• Use high quality patch cables to reduce noise pickup over long
distance runs.
16 COMPONENT VIDEO INPUT 1-3, COMPONENT VIDEO OUT
• Connect the Component Video Input to Component Video output
of compatible source components, typically a DVD player, BD
player, digital cable box or other applicable components. Connect
Component Video Out to the Component Video input of a
compatible video monitor/TV.
• Be sure to observe consistency in connecting the Y/Pb/Pr jacks
to the corresponding sources/inputs. The routing of the three
component video input is fully congurable via the Source Setup
item of the Setup Menu OSD.
• The T 758’s sets of component video input and output are fully
wideband and compatible with allowable HDTV formats.
17 SPEAKERS
• Connect the respective speaker’s FRONT L, FRONT R, CENTER,
SURR R, SURR L, SURR-BACK L, and SURR-BACK R channels to their
corresponding loudspeakers. Make sure the “+” (red) terminal and
“-” (black) terminal are connected to the corresponding “+” and “-”
terminals of the loudspeaker. Use extra care to ensure that no stray
wires or strands cross between posts or terminals at either end.
• SURR-BACK L and SURR-BACK R can be assigned as Zone 2 speaker
level output. This is applicable only if “Zone 2” is the selected setting
of “Back Amp” in the “Amplier Setup” menu. For further information,
refer to the item about ZONE CONTROLS at the USING THE T 758 -
MAIN MENU segment of the OPERATION section.
IDENTIFICATION OF CONTROLS
REAR PANEL
10
ENGLISH PORTUGUÊSFRANÇAIS ESPAÑOL ITALIANO DEUTSCH NEDERLANDS SVENSKA РУССКИЙ