NAMCO Ridge Racer 2 Upgrade Manual

namco 0
RAVE RACER’”
RIDGE RACER 2”
3.5 Power-Up and Initialization
The following procedure should always be performed at the time of initial power-up, or
when any of these components have been removed or replaced:
l Game PCBs
. ROMS
0 Steering system potentiometers
l Pedal assembly potentiometers ‘
1.
System initialization is performed as follows:
a. Open the coin door to gain access to the Service Panel.
b. Center the steering wheel and remove hands/feet from the controls.
C.
While pressing the SERVICE button, toggle the TEST switch ON.
d. The ADJUSTMENT screen will appear as shown in Figure 2.
ADJUSTMENT
HANDLE 000x
GAS 000x
BRAKE 000x
Figure 2: Adjustment (Initialization) Screen
e. Controls are properly biased when values are as close to ‘0000’ as
possible.
f.
Release the SERVICE button and toggle the TEST switch OFF.
5

NAMCO Ridge Racer 2 Specifications

General

Brand	NAMCO
Model	Ridge Racer 2
Category	Arcade Game Machines
Language	English