1312 Assembly Assembly
A S S E M B LY///
Drill a hole.
Use the anchor and the screw to hang the bracket.
This will help us figure out where the rest of our holes should go!
Adjust wall bracket angle by using the included level.
Mark the bottom 2 anchor holes.
Drill a 3/16" hole
in the marked spot and insert
the anchor until flush to wall.
Don’t tighten the screw
in all the way! You’ll see
why in the next step.
Use the screw to hang…
Adjust and find
the correct bracket
angle by using
included level.
While holding the bracket,
mark the bottom
2 anchor holes.
Take out
the bracket.
To Next Page
Loading...
