EasyManua.ls Logo

Nanni T4.270 - Maintenance Intervals

Nanni T4.270
98 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
55
MAINTENANCE INTERVALS
PERIODICITY
Daily
1st
Maintenance
30 days
or 25 hours (
1
)
Every
250 hours
or 1 year (
1
)
Every
500 hours
or 2 years (
1
)
Every
1000 hours or 4
years (
1
)
COMPONENTS
Fuel Circuit
Water in fuel - Pre-lter / Filter Draining
Fuel lter replacement (
2
)
Fuel injectors - Check Compensation Value with Diagnostic Tool (
4
)
Fuel Mechanical Injectors T6 Engines
Lubrication Circuit
Engine oil level (
2
)
Oil replacement (
2
)
Oil lter replacement (
2
)
Cooling Circuit
Coolant level (
2
)
Coolant Liquid (
2
)
Thermostat Inspection (
2
)
Calibrated Heat-Exchanger Cap (
2
)
Heat-exchanger - O-rings
Inter-cooler - O-rings
Raw Water Circuit
Raw Water Filter
Raw Water Pump Impeller (
2
)
Zinc Anodes (
2
)
Air Intake & Exhaust Circuit
Turbo-charger Inspection
Turbo Waste-Gate Free Movement & Lubrication
Turbo-charger Heat Insulator Replacement
Air Intake Filter (
2
)
Exhaust Mixer Inspection (
2
)
Electrical
Battery electrolyte level
Electrical Harness Connectors Inspection
Alternator Belt Tension (
2
)
Panel Command : Indicators & Warning Lamps
Read & Record Defect Trouble Codes (
4
)
Whole Engine
Engine Mounts Inspection - Replacement
Engine Alignment
Hoses / Clamps tightness / Bolts / Nuts Tightening
Visual Inspection (Coolant, fuel, oil, exhaust & raw water leaks)
Valve Clearance
Timing Belt (
5
)
Transmission
Transmission Oil level (
3
)
Transmission Oil (
3
)
Transmission Oil Filter (
3
)
Fuel & Transmission Oil Cooler
(
1
) Whichever come rst (at the rst occurrence)
(
2
) Operations to be performed in accordance with user and maintenance manual for your engine. For all technical information specic to your engine, refer to the user and maintenance manual.
(
3
) Operation to be perform in accordance with the manufacturer user and maintenance manual.
(
4
)
Mechanical injection engines T6.420TDI - T6.300 - T6.280 and Z6.300 are not concerned.
(
5
) V8 engines T8V320 - T8V350 and T8V370 are not concerned
CHECK/ADJUST/CLEAN/SERVICE/REPLACE IF NECESSARY REPLACE
S08 MAINTENANCE

Table of Contents

Related product manuals