To Next PageTo Next Page
Need help?Do you have a question about the NANO NanoVNA V2 and is the answer not in the manual?
General| Frequency Range | 50kHz - 3GHz |
|---|---|
| S-Parameter Measurement | S11, S21 |
| USB Interface | USB Type-C |
| Power | 5V DC |
| RF Connectors | SMA female |
| Calibration Type | SOLT (Short, Open, Load, Thru) |
| Display | 2.8 inch TFT LCD |
| Battery | Li-ion rechargeable battery |
Covers general settings like screen calibration, grid color, and firmware.
Guides on calibrating and testing the accuracy of the device's touch screen.
Explains how to define start, stop, center, and span frequencies for measurements.
Details the procedure for calibrating the device using standards like Open, Short, Load, and Thru.
Describes how to use markers to set frequencies and analyze data points on traces.
Explains how to simulate time domain reflectometry by transforming frequency data.
Details how to save, reset, and recall up to five calibration datasets and settings.
Provides step-by-step instructions for updating the NanoVNA V2 firmware using the PC software.
