56
Safety precautions
Review and follow the safety instructions below:
• If water or other material enters the instrument, adaptor, or power inlet, disconnect the power
cord and contact a service person. For operating environment, refer to Product Specifications.
• Do not touch the main plug or power cord with wet hands.
• Always ensure that the power supply input voltage matches the voltage available at your location.
• This instrument is air-cooled and its surfaces may become hot during operation.
During installing, leave a space of more than 10 cm (4 inches) around the instrument and do not
place any objects between the instrument and the walls.
• Do not install the instrument on a slant or a place prone to vibrations, which induces the risk of
instrument malfunction or damage of the instrument.
• Never insert any objects into the air vents of the instrument as this could result in electrical shock,
personal injury, and equipment damage.
• Plug the power cord firmly into the wall outlet and AC adapter.
• To avoid potential shock hazard, make sure that the power cord is properly grounded.
• Be sure to position the equipment such that it is easy to disconnect.
• Turn off the instrument before unplugging the power cord and/or moving the instrument.
• If the instrument is dropped or broken, disconnect the power cord and contact a service person.
Disassembly of case will void warranty.
• Use only authorized accessories (adaptor, power cord, and USB drive).
Warning
Class A equipment is intended for use in an industrial environment.
In the documentation for the user, a statement shall be included drawing attention to the fact that
there may be potential difficulties in ensuring electromagnetic compatibility in other environments,
due to conducted as well as radiated disturbances.
To Next Page
Loading...
Need help?
General